Télécharger Imprimer la page

Legend Brands Dri-Eaz 700 Guide De Mise En Route

Epurateur à filtre hepa

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

ELECTRIC SHOCK HAZARD
The unit must be electrically grounded. Use only on
GFCI protected receptacles.
Connect to a properly grounded outlet only. Do not cut
off the grounding prong. Do not use with an adapter.
Do not use with extension cords.
Do not use with damaged cord or plug. If unit is not working as
it should, has been dropped, damaged, left outdoors, or
exposed to water, return it to an authorized service center for
repair.
Unplug cord from outlet when not in use or when servicing unit.
ELECTRIC SHOCK HAZARD
Keep motor and electrical parts dry.
Do not use outdoors. For indoor use only.
Do not handle plug or unit with wet hands.
Do not operate unit in standing water.
BREATHING HAZARD
When using the HEPA 700 in a containment area, turn
off all sources of power to open combustion
appliances such as fireplaces, boilers, furnaces, water
heaters and HVAC systems to avoid the risk of backdrafting
deadly carbon monoxide fumes.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy, and if not installed and
used in accordance with the instructions, may cause harmful
Parts Identification
Filter cover buckle
(×4). Release to
replace filter
elements.
Air intake
ring. Attach
14 in. semi-
rigid ducting.
Inlet and
inlet cover.
Remove
cover before
operating.
125385D HEPA 700
Quick Start Guide
HEPA 700 Air Scrubber
Control panel.
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for
help
SPECIAL FEATURES
Command Hub Technology
Integrated Command Hub technology with the free Command
Center mobile app enables firmware updates and 24/7
monitoring and control to ensure optimal air filtration. (App
available soon in Apple and Google Play stores.)
Ducting options
Inlet: 14 in. wire reinforced ducting (purchased separately).
Outlet: 14 in.(diameter) layflat or wire reinforced ducting
(purchased separately) using the provided duct attachment
ring. Do not exceed a maximum ducting length of 25 ft. / 7.6 m.
OPERATING INSTRUCTIONS
Setup
1. Unwrap the cord completely.
2. Place the HEPA 700 with the handle up. Ensure that neither
the inlet nor the outlet are obstructed.
3. Plug into a standard 115V GFCI-protected outlet.
Carry handle.
Folds down when
not in use.
Feet for
horizontal
operation &
stacking.
115V outlets
(×2) and
breaker reset
switch.
Use the hook-and-pile
fasteners to attach the inlet
cover here while unit is use.
1
Filtered air
outlet. Filter
retainer ring may
be used to
attach 14 in.
layflat ducting.
Legend Brands, Inc.

Publicité

loading

Sommaire des Matières pour Legend Brands Dri-Eaz 700

  • Page 1 14 in. semi- stacking. rigid ducting. 115V outlets (×2) and breaker reset switch. Inlet and inlet cover. Remove cover before operating. Use the hook-and-pile fasteners to attach the inlet cover here while unit is use. 125385D HEPA 700 Legend Brands, Inc.
  • Page 2: About The Filters

    HEPA filter remove particulates and carbon filter adsorbs odors. See Owner’s Manual for asbestos remediation guidance. For parts and service, contact your local dealer or Legend Brands, 15180 Josh Wilson Rd., Burlington, WA 98233 Live Chat: Info.legendbrands.com | Email: Service@legendbrandsrestoration.com...
  • Page 3: Guide De Mise En Route Rapide - Hepa 700

    115 V (×2) et interrupteur de Admission et réenclenchem couvercle d’admission. Retirez le couvercle avant Utilisez les attaches à bande l’utilisation. Velcro pour fixer le couvercle d’admission ici pendant que l’unité est en service. 125385D HEPA 700 Legend Brands, Inc.
  • Page 4: Remplacement Des Filtres

    IMPORTANT : Pour une performance de filtration maximale, IMPORTANT : N’utilisez que des filtres HEPA 700 de la utilisez seulement des filtres de la marque Legend Brands. Ne marque Legend Brands. Les performances sont réduites tentez pas de nettoyer et de réutiliser le filtre HEPA.
  • Page 5: Peligro De Descarga Eléctrica

    Entrada y de reinicio del tapa de disyuntor. entrada. Retire la tapa antes de operar. Utilice los sujetadores de velcro para sostener la tapa de entrada aquí mientras se usa la unidad. 125385D HEPA 700 Legend Brands, Inc.
  • Page 6 Legend Brands. Cuando un filtro funcionamiento sera reducido. primario que no pertenesca a Legend Brands sea instalado el funcionamiento sera reducido. No intente limpiar y reutilizar el Revise y sustituya regularmente los prefiltros y el filtro filtro HEPA.