Defrosting; Cleaning & Maintenance; Troubleshooting - Inventum CKV501++ Mode D'emploi

6

defrosting

Defrost the freezer compartment when the layer of ice reaches a thickness of 3 to 5 mm.
Turn the thermostat (2) to OFF and unplug the appliance. Keep the contents of the freezer in a cool place and wrapped in
blankets or newspapers.
Place a container under the freezing compartment (4) and wait for the ice to defrost. You can speed up the defrosting
process by placing a bowl of hot water in the freezer.
Remove the ice with the included ice scraper.
Warning: Never remove the ice with the aid of sharp objects, defrost sprays, a hair-drier, a heater, or similar items. This may
lead to unsafe situations and may cause irreparable damage to the appliance.
Clean and dry the freezer comparment. Switch the thermostat on to the right setting. When the freezer compartment
reaches its correct temperature, replace the food items.
7
cleaning & maintenance
Frost can settle on the rear wall of the cooling compartment. It is removed automatically.
Before cleaning the appliance set the thermostat to OFF and always unplug the appliance.
Clean the interior of the appliance. Use warm water and a neutral detergent to prevent any bad smells occurring. After
cleaning, rinse the interior with clean water and rub dry. Leave the appliance to dry for 1 to 2 hours. Simply remove the
shelves, drawer and door compartments to clean them by hand. Do not clean the interior accessories in the dishwasher.
Clean the outside of the appliance and the gasket with a soft moist cloth.
REPLACING THE LED LIGHTING
This appliance is equipped with a LED light bulb. It can be used for a long time. In case, the LED bulb is blown, it must be
replaced by a qualified person to avoid any hazard. Contact the Inventum service department.
8

troubleshooting

Problem
Appliance is not functioning;
light does not work
Temperature inside the
larder is too high or too low
Appliance is excessively noisy
Note: gurgling and hissing noises due to expansion in the refrigerant circuit are normal.
Cause
Appliance is not plugged in
Thermostat has been set incorrectly
Air circulation vents are blocked
Has the appliance been installed correctly?
Are the pipes at the back touching or
vibrating?
Solution
Plug the appliance in the socket
Set the thermostat correctly
Clean the ventilation openings
Check the installation
Check it and move the appliance
forwards
English
17
•