Maintenance, Inspection And Control; Using Instructions - Sima C-6/22 Manuel D'utilisation

4.2 MAINTENANCE, INSPECTION AND CONTROL

To keep the shear in good conditions, you need to control periodically the following points:
1 After each day of work, check the condition of the shear and replace them if blunt.
2 Lubricate after each 5 days of work the cogwheel rotation spindles and the mandible
3 Grease each 2 months of use the mandible cogs and cogwheel.

5. USING INSTRUCTIONS

The manual shears have been designed and manufactured to cut flat and reinforced steel bars for construction.
Therefore, it is expressly prohibited. Adding any tool or accessory, or bringing any modification to the machine without
written authorization from the manufacturer is considered inappropriate and can be dangerous.
STEPS TO FOLLOW WHEN PERFORMING A CUTTING
1 Fix the shear on a firm surface with the special drill for this use, making sure the machine remains stable
2 mount the handle supplied with the machine and the cogwheel stem.
3 Place the bar to cut between the blades and push the lever until the cut is performed. The curved form of
the lever together with the design of the machine allow cutting in two attacks with only changing the
position of the lever.
The models C6/28 and C6/32 have a positioning bolt in the cogwheel stem B, Fig.2 that allows regulating the
opening between the blades, according to the thickness of the material to be cut. To avoid the rods crossing in the
blades at the time of court, the shear has an adjustable screw for the bar resting. T, Fig. 2
2
3
T
5
ENGLISH
B