in-lite SENTINA 150X150 Manuel D'utilisation page 8

EN
Contents
1x SENTINA 150X150 12 V / 3.5 W
Dimensions 150 x 150 mm / 5.9 x 5.9 inches
Recess depth 100 mm / 3.9 inches
1x Easy-Lock
1x Torx key
Material
Impact-resistant polycarbonate lens
Stainless steel cover plate
Please read the following instructions before installing. You are
advised to keep these installation instructions in a safe place.
Although a 12 V system is safe, we advise you to have a qualified
electrician check the installation.
Use
Integrated accent lighting for special features in the yard such as
trees, shrubs, statues and exterior walls.
This fixture is fitted with a tilting light unit. To use this loosen the four
Torx bolts and remove the cover and lens. Tilt the light unit into the
desired position (it can be raised or lowered max. 15 degrees), and
replace the lens and cover. Retighten the Torx bolts.
Lamp
The fixture is equipped with a high-quality LED lamp. These lamps
have a long life (about 25,000 hours) and a high light output and their
power consumption and the heat produced are extremely low.
Important!
Never connect the low-voltage cable directly to a 100-240 V power
source. It is only suitable for use in combination with a 12 V low-voltage
system. This product should only be used within the in-lite system. Use
of products other than those made by in-lite will invalidate the warranty.
Enjoy the lighting in your yard.