Samson Expedition Express+ Mode D'emploi page 9

Quick Start
XPD Wireless Input (sold separately)
•
Plug the XPD USB receiver into the XPD
Wireless USB jack.
•
Turn the MIC/LINE VOLUME knob on the
Express+ completely counterclockwise to 0.
•
Place a fresh set of AA (LR6) batteries in the
transmitter battery holder, taking care to observe
the polarity markings, then replace the cover.
•
Turn on the power to the transmitter by pressing
and holding Power switch; the indicator LED will
light amber.
•
Speak or sing into the mic at a normal
performance level and raise the MIC/LINE
VOLUME control until the desired level is
reached.
Bluetooth®
•
Turn the BLUETOOTH VOLUME control down
counterclockwise to 0.
•
With the Express+ and your Bluetooth device
powered on; press the PAIR button on the rear
panel of the Express+ to make the speaker
discoverable. The Pairing indicator will slowly
flash blue.
•
In the settings of your Bluetooth device, set it to
"discover" available devices.
•
From the Bluetooth device list, select the
"Express Plus" device.
•
If your device asks for a passkey, enter digits
0000 (four zeros) and press OK. Some devices
may also ask you to accept the connection.
•
The Express+ speaker indicates that pairing is complete when the indicator turns
steady blue. You can now stream audio from your device to the Express+ speakers.
•
With the volume control on your Bluetooth device turned up, play some music, and
slowly raise the Express+ LINE/BLUETOOTH VOLUME control until you have reached
the desired level.
Expedition Express+ • Portable PA System 9