Aquaglide RECOIL TRAMP 14.0 Manuel Du Propriétaire page 6

Inflatable Products – Aquaglide makes some of the highest quality inflatable products in the world.
With proper care and maintenance, our products are expected to last for years under normal use. We list
important tips and instructions below. If unsure about any point, please reach us through our website at
Aquaglide.com/contact-us.
Note: see Anchoring instructions (below) before inflating this item. Strong winds can make it difficult to
control this product. Be aware of weather conditions before installation.
Air Pump - Use an air pump recommended for inflating your product. For products this size, use of a
high-volume electrical pump is best. Air pressure requirements are low – 5.0psi (0,35bar) or less. Air
compressors designed for high-pressure inflation are not recommended because they can easily lead to
over-inflation.
Valve(s) – This product uses a Halkey Roberts – type (HR) valve. Valve
attaches to product using a threaded backing plate, making it easily
replaceable in the unlikely event of damage.
Access valve using a coin or flat tool to twist the tamper-resistant cap counter-
clockwise. To close, insert the cap and twist clockwise using the same tool.
Note: cap is the secondary air seal. See valve operation. See A.
To inflate, an air pump with Halkey Roberts – type (HR) valve
fitting is required. Insert fitting into valve and twist clockwise to
lock in place. See B.
Valve Operation: To operate Halkey Roberts – type (HR)
valve, press plunger and turn 90 degrees to set valve for inflate
and product use (plunger out = 1-way airflow). Press plunger
and turn 90 degrees to deflate (plunger in = 2-way airflow).
Note: valve is primary air seal. After inflation, close with cap for
secondary seal. See C.
Proper Working Pressure for each chamber is listed
below. Do not overfill or underfill. Excessive pressure
can cause damage to the product and may void the
warranty. Do not use without adequate air pressure.
Product can become unstable if underfilled and may
not support indicated capacity. Use a pressure gauge
(manometer) to carefully monitor air pressure in the product especially during hot or cool periods.
Chart 1 – Working Pressure by Chamber – Recoil Tramp 14.0
Valve [Inflate Order]
Recoil 14.0 - Main [1]
C-Deck Platform - Main [1]
1. Locate a flat, dry area with access to outlet for electrical pump. The best setup position will also make
launching easy. Never drag product as damage may occur.
2. Unfold product completely and locate Main Valve [1]. To help future storage, closely note original
folding & packaging method. Remove valve cap and confirm valve is in inflate (1-way airflow) position.
3. Insert air pump hose with proper valve fitting into Main Valve [1], lock into place. Use pump to inflate
Main Valve [1] to Working Pressure as shown in Chart 1. Check for proper pressure using gauge
(manometer). Replace valve cap.
6
ASSEMBLY
C
Working Pressure in psi (Bar)
1.2 psi (0,083 bar)
0.8 psi (0,055 bar)
A
B
Inflate (1-way) Deflate (2-way)
www.aquaglide.com