Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
d)
The outside diameter and the thickness of your accessory must be within
the capacity rating of your power tool. Incorrectly sized accessories cannot be
adequately controlled.
e)
The arbour size of wheels, sanding drums or any other accessory must properly
fit the spindle or collet of the power tool. Accessories that do not match the
mounting hardware of the power tool will run out of balance, vibrate excessively and
may cause loss of control.
f)
Mandrel mounted wheels, sanding drums, cutters or other accessories must
be fully inserted into the collet or chuck. If the mandrel is insufficiently held and/
or the overhang of the wheel is too long, the mounted wheel may become loose and be
ejected at high velocity.
g)
Do not use a damaged accessory. Before each use inspect the accessory such
as abrasive wheels for chips and cracks, sanding drum for cracks, tear or
excess wear, wire brush for loose or cracked wires. If power tool or accessory
is dropped, inspect for damage or install an undamaged accessory. After
inspecting and installing an accessory, position yourself and bystanders away
from the plane of the rotating accessory and run the power tool at maximum
no-load speed for one minute. Damaged accessories will normally break apart during
this test time.
h)
Wear personal protective equipment. Depending on application, use face
shield, safety goggles or safety glasses. As appropriate, wear dust mask,
hearing protectors, gloves and workshop apron capable of stopping small
abrasive or workpiece fragments. The eye protection must be capable of stopping
flying debris generated by various operations. The dust mask or respirator must be
capable of filtrating particles generated by your operation. Prolonged exposure to high
intensity noise may cause hearing loss.
i)
Keep bystanders a safe distance away from work area. Anyone entering the
work area must wear personal protective equipment. Fragments of workpiece
or of a broken accessory may fly away and cause injury beyond immediate area of
operation.
j)
Hold power tool by insulated gripping surfaces only, when performing an
operation where the cutting accessory may contact hidden wiring. Cutting
accessory contacting a "live" wire may make exposed metal parts of the power tool
"live" and could give the operator an electric shock.
k)
Always hold the tool firmly in your hand(s) during the start-up. The reaction
torque of the motor, as it accelerates to full speed, can cause the tool to twist.
l)
Use clamps to support workpiece whenever practical. Never hold a small
workpiece in one hand and the tool in the other hand while in use. Clamping a
small workpiece allows you to use your hand(s) to control the tool. Round material such
as dowel rods, pipes or tubing have a tendency to roll while being cut, and may cause
the bit to bind or jump toward you.
m) Position the cord clear of the spinning accessory. If you lose control, the cord may
be cut or snagged and your hand or arm may be pulled into the spinning accessory.
n)
Never lay the power tool down until the accessory has come to a complete stop.
The spinning accessory may grab the surface and pull the power tool out of your control.
EN
5
Publicité
Table des Matières
