Installing And Removing The Battery Pack - DeWalt DCE512 Guide D'utilisation

Suspending/Mounting the Fan (Fig A, E)

CAUTION: When the fan hangs by the hang hooks, do
not shake the fan or the object from which it hangs. Do
not hang the fan from any electrical wires or anything
that is not secure. Personal injury or property damage
may occur.

CAUTION: Only use the hang hooks for hanging
the fan as shown in Fig. A. The hang hooks are not
intended to support additional weight. Do not attach
or hang anything additional to the fan or risk of
breakage may occur.

CAUTION: Do not use the hang hooks to reach with or
to support your weight in any situation.

CAUTION: Do not stand underneath the fan when it is
mounted overhead. Serious personal injury or damage
to the fan may result if the fan falls.

CAUTION: Do not mount the fan to the ceiling.
nOTE: Locate the fan away from a corner or other
obstructions which may impede air flow.
Your jobsite fan has multiple options for mounting.
hang hooks
The built‑in hang hooks 4
can be used to suspend the fan from 2X lumber as shown.
Be sure to fully extend the hooks before using, then rotate
as needed.
Keyhole slots (Fig. E)
If using the keyhole slots
each side, secured into a sturdy surface.
1. Place the wide portion of the keyhole slot over the head
of the screw.
2. Slide the jobsite fan down until the screw is inside the
narrow portion of the keyhole and check to be sure the
fan is secure.
Carrying the Fan (Fig. A)
Carry the fan using the top handle
Adjusting the Fan Angle (Fig. A)

WARNING: Keep fingers away from the front and rear
grill of the fan.
This fan has soft detents to maintain multiple angles. To
adjust, gently push or pull the fan handle
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start‑up can cause injury.

Installing and Removing the Battery Pack

(Fig. A, D)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
pack with the rails inside the fan's battery nook
telescope out of the back legs and
7 , use at least 2 screws, one on
3 .
3 .
5 into the fan, align the battery
2
it in until the battery pack is firmly seated and ensure that it
does not disengage.
To remove the battery pack from the fan, press the release
button
6
battery nook. Insert it into the charger as described in the
charger section of this manual.
Turning the Fan On and Off (Fig. A)
To turn the fan ON, rotate the control knob
To turn the fan OFF, rotate the control knob
counterclockwise until it clicks.
Fan speeds are variable and can be adjusted by the
control knob.
MAINTENANCE

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start‑up can cause injury.
Your D WALT power tool has been designed to operate
e
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
Cleaning

WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this procedure.

WARNING: Never use solvents or other harsh
chemicals for cleaning the non‑metallic parts of the
tool. These chemicals may weaken the plastic materials
used in these parts. Use a cloth dampened only with
water and mild soap. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
Accessories

WARNING: Since accessories, other than those offered
by D
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
Recommended accessories for use with your tool are available
at extra cost from your local dealer or authorized service
center. If you need assistance in locating any accessory, please
contact D
e
visit our website: www.dewalt.com.
Repairs
The charger and battery pack are not serviceable. There are
no serviceable parts inside the charger or battery pack.

WARNING: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (including brush
inspection and replacement, when applicable) should
be performed by a D
D
e
replacement parts.
and slide
and firmly pull the battery pack out of the fan's
WALT, have not been tested with this product, use
e
WALT call 1‑800‑4‑D WALT (1‑800‑433‑9258) or
e
WALT factory service center or a
e
WALT authorized service center. Always use identical
English
clockwise.
1
1
WALT recommended
e
7