Table des Matières
Publicité
Before You Begin
CAUTION: Risk of property damage. Use color-matched 100% silicone sealant to
the required areas when instructed. Do not use latex-based sealant or other caulks.
Do not add silicone sealant to any other areas. The inappropriate type and
application of sealant may trap moisture and could result in mold, leakage, or
mildew over the life of the product.
NOTICE: For baths with apron braces: If the bath shipped in multi-pack cartons,
attach the apron braces to the apron before removing the bath from the carton. Lift
the bath at multiple points on its sides when removing it from the carton or moving
it into position. Do not lift or move the bath by the apron or apron braces.
NOTICE: Risk of product damage. Do not remove the foam backing from the wall
surround sections. Wall surround sections are equipped with foam backing to bring
the back of the wall into contact with the regular stud framing. This foam is not
packing material.
NOTICE: Risk of product damage. Select truss head screws that are galvanized. The
coating on the screws will eliminate the occurrence of rust marks on your product.
NOTICE: Risk of product damage. To prevent surface damage to the bath, keep the
protective liner in place on the bath until construction is complete.
Read all instructions before you begin.
Observe all applicable plumbing and building codes.
This bath is designed for alcove installations.
Upon receipt, check for missing parts or damage to the bath. Report any missing
parts or damage immediately.
Store the bath and wall surrounds in a safe place until you begin installation to
avoid damage.
For remodeling installations: (1) Measure the existing framework before removing
the existing bath to make sure that the new bath will fit in the existing framework.
(2) Make sure that the drain outlet and drain line are in the correct location.
Confirm adequate mounting and connection space for the water supply and drain
installation.
The apron panel is not removable on bath units.
Sterling reserves the right to make revisions in the design of products without
notice, as specified in the Price Book.
Avant de commencer
ATTENTION: Risque d'endommagement du matériel. Utiliser un mastic
d'étanchéité à la silicone avec couleur correspondante à 100 % sur les zones
requises lorsqu'indiqué. Ne pas utiliser de mastic d'étanchéité à base de latex ni
d'autres mastics isolants. Ne pas rajouter de mastic à la silicone à d'autres
endroits. Un type et une application non appropriée de mastic peut emprisonner
l'humidité et ceci pourrait entraîner de la moisissure ou des fuites sur la durée de
vie du produit.
NOTICE: Pour les baignoires avec supports de bandeau: Si la baignoire a été fournie
dans des cartons à plusieurs paquets, attacher les supports de bandeau sur le
bandeau avant de retirer la baignoire de l'emballage. Lever la baignoire à plusieurs
endroits sur ses côtés avant de la retirer de l'emballage ou de la mettre en position.
Ne pas soulever ni déplacer la baignoire par le bandeau ou des montants du
bandeau.
Sterling
3
1064906-2-C
Publicité
Table des Matières
