Anslut STRIP LIGHT LED Mode D'emploi page 15

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 23
EN
AFTER INSTALLATION IN LIGHTS
WITH ELECTRONIC ACTUATOR
Conventional T8 strip light
A = Electronic actuator.
FIG. 5
LED strip light
1.
Remove the electronic actuator (B) as
shown in the figure below.
2.
Connect a direct wire between pin 2 and 3
on the light.
3.
Connect pin 1 to the mains phase (L) and
pin 4 to neutral (N).
B = Electronic actuator.
FIG. 6
12

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

019934

Table des Matières