GEDO PROFOAM Notice Technique page 9

1) Check that the w and w ater valve "D" is closed.
2) Open w ater ball valve "A".
3) Open air valve "C".
4) Open the w and w ater valve "D", orientate w and in direction
of surface to treat.
5) Regulate air pressure acording to expected results.
Unlock by pulling dow n the button "B" and regulate pressure by turning
button. When the result is ok, lock the regulator by pushing up button "B"
6) After use, please close the follow ing valves: w and "D", air "C", w ater "A".
METHOD OF DILUTION CALCULATING
EXEMPLE: 15 (A) x 100%= 1.5%
1000 (B)
Volume A
(15 cl ou 150 ml
)
Volume A : Suckeded product
Volume B : solution (water + breathed product)
Foam unit PROFOAM – Instructions for use
A
Closed
Open
USE
( this drawing is an exemple )
Closed
Open
ALWAYS orientate spray in direction of surfaces to treat.
Chemical compatibility of used product MUST ALWAYS be checked.
NEVER orientate spray in direction of people, animals or plants
ALWAYS w ait few seconds for a good product and w ater mix ing.
ALWAYS close w ater inlet v alv e after each use.
WATER PRESSURE must be included on 2 bar to 6 bar.
MAXIMUM w orking temperature is 50°C
ALWAYS keep the unit on frost protection
DILUTION CHART - PROFOAM UNIT
transparent
purple
turquoise
y ellow
dark brow n
Volume B
orange
(1000 cl ou
green
10 000 ml)
This chart is done to allow you choose a tip in
function of the needed concentration.
20m hose lengh
Dynamic w ater pressure = 2,5 Bar (cold w ater)
Suctioned product : Foaming detergent density:1
D
Closed
Open
B
C
CAUTION
light brow n
1,50% w hite
2,00% red
3,00% beige
4,00% black
5,00% grey
6,00% w ithout tip
Condition tests:
NTMOPSLB V.03.3 p.9/13
GB
8,00%
14,00%
15,00%
20,00%
22,00%
22,00%
22,00%