Publicité
Les langues disponibles
Les langues disponibles
GB
The ITZ-505 timer is suitable for up to 16 intertechno wireless receivers (Fig.1).
Wireless adapter plugs and built-in switches, e.g. switches to operate blinds,
can be time-controlled.
It can be used as a hand-held transmitter for all self-learning wireless receivers,
even while set as an active timer.
A wall bracket for storage is included. The bracket can be mounted using the
enclosed screws or with double-sided adhesive tape is (Fig.2).
Preparation: Setting the time
Hold the "CLOCK" button for around three seconds until the LCD display blinks.
•
Set the hour using the „▼▲" buttons. Press "ENTER" to save.
•
Set the minutes with the „▼▲" buttons. Press "ENTER" to save.
•
The timer is now ready for use.
Coding: Teaching-in wireless receivers
Read the instruction manual to adjust the wireless receiver's coding.
The «UNIT» button is used to select the code 1-16 (Fig.1).
Teach the coding by pressing the «ON» button when the wireless receiver is
ready to learn.
Another receiver can now be taught-in.
There are three different timer modes available
r
)
A) Daily cycle: (
B) One-off: (
C) Security mode: (
selected switch times
Gives the impression of someone being there (burglary protection)
Timer settings
1) Press the "TIMER" button for around three seconds:
2) Enter the save location (1-12), using the „▼▲" buttons.
Confirm with "ENTER"
3) Enter the device number (1–16) using the "UNIT" button.
Confirm with „ENTER"
4) Enter the on/off times using the „▼▲" buttons.
Confirm with "ENTER"
5) Select the TIMER modes using the „▼▲" buttons (
Confirm with "ENTER"
6) Short press the "TIMER" button to finish.
Checking the timer settings
Press the "TIMER" button for three seconds and select a save location using
the „▼▲" buttons.
Short press the "TIMER" button to exit.
Operating instructions
) Activates the selected switch times daily
) Activates the selected switch times once
) The timer switches on and off randomly within the
ITZ-505
,
or
).
›
Publicité
