Campbell Hausfeld AR2089 Instructions D'utilisation Et Manuel De Pièces page 2

Operating Instructions and Parts Manual
Installation
(Continued)
should be used between the tank
legs and the floor. Isolator pads are
recommended (for horizontal tank
pad set use part number
MP345800AJ and for vertical tank
pad set use part number
MP345700AJ). Air compressor
should be mounted on a flat, even
surface.
NOTE: When using isolator pads, do
not draw bolts tight. Allow pads to
absorb vibrations.
IMPORTANT: When isolators are used,
a flexible coupling should be installed
between tank and service piping.
CAUTION
!
Never use wooden shipping skid(s) as
vibration isolators.
CAUTION
!
Unsecured tanks can result in electrical
hazard and fire due to electrical supply
cable becoming disconnected.
WARNING
!
Never drill or weld the pressurized part
of air tanks.
Cal - OSHA code 462 (L) (2) listings
Tank
Model No.
AR2089
AR2090
www.chpower.com
2. When equipment is installed on the
tank, always provide appropriate
belt guard and shields to prevent
contact with moving or hot parts.
3. Do not weld or modify the
pressurized part of the tank. It is
allowable to drill holes in the base-
plate only for the purpose of
mounting the pump or guards.
WARNING
!
No other product alteration or
modification is advised.
REMOVAL OF INSPECTION PLUG
To remove the ASME Inspection Plug
from 30 gallon tanks, use a wrench
with a jaw opening of 2
counterclockwise.
INSTALLATION OF ASME
INSPECTION PLUG
To install the ASME Inspection Plug on
30 gallon tanks, use a wrench with a
jaw opening of 2
O-Ring on the ASME Inspection Plug is
present and in place. Torque
(clockwise) the plug from 42 ft. Ibs.
minimum to 100 ft. Ibs. maximum.
WARNING
!
Failure to comply with these guidelines
can result in personal injury and/or
property damage due to tank failure.
Gallons/ Compatible Single Stage
Type Pump
30 Horiz. VS2079
VT4710
VT4711
VT4712
VT4713
30 Vert. VS2079
VT4710
VT4711
VT4712
VT4713
/ ". Turn
1
8
1 / ". Be sure the
8
RPM
930
}
1000
1000
Do not use gas or diesel engines
1000
1000
750
}
1000
1000
Do not use gas or diesel engines
1000
1000
2
AR2089, AR2090
Operation
CAUTION
!
● These tanks are designed and
intended to be used as air receivers
only.
● Do not exceed maximum allowable
compressor and motor size. See
Specifications.
● Maximum pressure of tank should
not exceed 200 PSI.
Maintenance
WARNING
!
Drain moisture from tank daily. Failure
to drain tank can result in weakening
due to rust and bursting.
Use electric motors only
Use electric motors only