Technical Information; Installation Considerations - Hansgrohe Focus E 319201 Serie Instructions De Montage / Mode D'emploi / Garantie

English

Technical Information

Water pressure
Recommended
Maximum
Hot water temp.
Recommended
Maximum
Max. flow rate
04370XX0, 04371XX0,
04510000, 31539001
31920XX1
Hole size in mounting surface
Max. depth of mounting surface
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.

Installation Considerations

• For best results, Hansgrohe recommends that this unit
be installed by a licensed, professional plumber.
• Please read over these instructions thoroughly before
beginning installation. Make sure that you have all
tools and supplies needed to complete the installation.
• The drain is intended for use in a sink with an overflow.
If your sink does not have an overflow, or if this drain
is too small for the hole in your sink, please refer to the
instructions included with the sink. Some sinks include
special drain installation instructions and/or parts.
Others require the use of a specialty drain. Hansgrohe
is not respnsible for the cost of a specialty drain.
• 04510000, 31539001 only: This faucet does not
include a drain or a pull rod.
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
120°-140° F (48° - 60° C)*
158°F (70° C)*
1.2 GPM (4.5 L/min)
2.2 GPM (8.3 L/min)
1½" (38 mm)
1⅛" (30 mm)
• Model #31920XX1 only: The discharge water
temperature from a bidet fitting shall be limited to a
maximum temperature of 110ºF (43ºC) by a water
temperature limiting device conforming to ASSE 1070.
• The hot and cold supply hoses included with this faucet
are for use with ⅜ stops. If your stops are a different
size, install new stops. Adapters are not available from
Hansgrohe.
• Keep this booklet and the receipt (or other proof of
date and place of purchase) for this product in a safe
place. The receipt is required should it be necessary to
request warranty parts.