Description of the appliance
A. Motor and lamp switch panel
B. Metal filter grill (grease filter)
C. Housing cover
D. Hob light
Standard accessories included:
Screws for mounting
Duct with no return valve
Function
The hood may be used as follows:
- For air exhausting
- For air recycling
Exhausting
The air is vented outside by means of pipes to be
connected to the duct supplied (bajonet coupling +
fixing screw) with no return valve (Fig. 2) on top
side of the hood.
Attention! In the horizontal runs the duct must be
slightly slanted (about 10°) and directed upwards
to vent the air easily from the room to the outside.
The hood cannot be connected to flues
of other appliances that run on energy
sources other than electricity.
Recycling
The air is filtered through a carbon filter and
recirculated into the room. The filtered air is
discharged by means of a Ø120 mm pipe which
goes through the cupboard and whose outlet is
above the cupboard.
This version is used when there is no exhaust duct
for venting outdoors or when it is impossible to
install one.
Special accessories
Active carbon filter
When the hood is used in recirculation mode an
active carbon filter should be used.
Order by the retailer
PNC 955 101 116 (B,CH,D,Sk)
941 196 401 (P)
A
0
1
2
3
C
Fig. 1
Ø 120mm
Fig. 2
45
A
B
D