Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE
To reduce the risk of injury, always
WARNING
unplug the charger and remove the
battery packs from the charger or mower before
performing any maintenance. Never disassemble
the mower, battery pack or charger. Contact a
MILWAUKEE service facility for ALL repairs.
Transportation
Remove the battery packs before
WARNING
transporting the mower. Always
clear the area of obstructions before transport-
ing.
• Use full width ramps for loading and unloading
a mower for transport. If full width ramp is not
available, use two people to lift the mower.
• Do not transport mower in the upright position.
• Keep tie-downs away from the controls and
adjustment levers.
• Remove grass bag before transport.
Removing/Installing the Cutting Blade
1. Remove battery packs.
2. Turn the mower on its side.
3. Wedge a block of wood between the blade and
the mower deck to prevent the blade from turning.
4. Remove the blade nut by turning it counterclock-
wise (as viewed from bottom of mower) using a
18 mm wrench or socket.
5. Remove the blade nut, washer, shear plate, blade,
blade motor fan, and spacer.
6. Use only mild soap and a damp cloth to clean the
components to remove grass clippings, leaves,
dirt, and any other accumulated debris.
7. Inspect the blade. Discard the blade if it is bent,
cracked, or damaged. Sharpen the blade accord-
ing to "Sharpening the Cutting Blade". WARNING!
An unbalanced blade can cause vibration that
could damage the mower or cause personal injury.
8. Install a new or sharpened blade. The circle and
triangle holes of the blade must align onto the
circle and triangle posts of the blade motor fan. The
shear plate edges must wrap around the blade.
9. Tighten the blade nut to 313-347 in.lbs, using a
torque wrench.
Sharpening the Cutting Blade
Keep cutting edges sharp and
WARNING
clean for best and safest perfor-
mance. Use a recommended MILWAUKEE re-
placement blade only. Use caution when servic-
ing blade. Wrap the blade or wear gloves. Replace
damaged blade. Do not repair damaged blade or
alter blade mounting holes.
1. Clean the blade.
2. Sharpen a dull blade equally at each end to main-
tain the balance. Use a file to remove minimal
shavings to achieve a sharp blade.
3. Check the blade's balance by supporting it on a
nail through its center hole. Hold the nail horizon-
tally. If either end of the blade rotates downward,
remove some metal from the heavy or lower end.
Repeat until the blade is balanced evenly on the
nail. It is balanced when neither end drops.
Maintaining Mower
Keep your mower, battery packs and charger in good
repair by adopting a regular maintenance program.
Inspect your mower for issues such as undue noise,
misalignment or binding of moving parts, breakage
of parts, or any other condition that may affect the
mower operation. Return the mower, battery pack,
and charger to a MILWAUKEE service facility for
repair.
If the mower does not start or operate at full power
with a fully charged battery pack, clean the contacts
on the battery pack. If the mower still does not work
properly, return the mower, charger and battery pack,
to a MILWAUKEE service facility for repairs.
10
Spindle
Spacer
Blade Motor Fan
Blade
Blade
Nut
Shear Plate
Square Washer
Publicité
Table des Matières
