Door Reversal - GE GCE06GGHWW Manuel D'utilisation Et D'installation

Installation Instructions

Door Reversal

1. Remove the small plug button on the left side of the door top cap.
2. Remove the 2 plug buttons or screws on the left side on top of the cabinet.
3. Remove the screw from the hinge cover, then remove the hinge cover by lifting it up
by the front edge.
4. Remove the 2 screws from the top hinge.
5. Lift the door up and off the bottom hinge (right side).
6. Tilt the refrigerator cabinet back to remove the right leveling leg.
7. Remove the screws on the bottom hinge (right side) and remove the leveling legs, as
well as plastic door stop. Move the bottom hinge and door stop to the left side and
secure it with screws. Re-install the leveling legs
IMPORTANT: The left leg has a spacer or spacer feature that must be moved to the
right side leveling leg when the door swing is reversed.
8. Screw the right leveling leg, with the spacer in place, back in place on the right side.
9. Position the door on the left bottom hinge. With the magnetic gasket holding the door
in place, secure the top hinge with screws.
10. Make sure the door is aligned with the refrigerator cabinet before continuing.
11. Replace the hinge cover on top of the hinge.
12. Put the plug button in the hole on the right side of the door cap.
13. Put the 3 (2 on some models) plug buttons on the right side on top of the cabinet
10
Hinge cover
Plug
buttons or
screws
Plug
button
Spacer
Hinge
Bottom
hinge
Leveling legs
49-60705 Rev. 3