Installation Considerations - Autoleads ADI-300 Mode D'emploi

Installing the ADI-300

Installation Considerations

Vehicle Requirements
Audio system with either an FM receiver or 3.5mm auxiliary input
u
12-24V negative earth power system
u
Position of the Active Antenna
The antenna is designed to be mounted directly onto the inside of the windscreen.
Power to the antenna is provided directly from the ADI-300 via the coaxial cable.
u In vehicles with polarised windscreens, it is advised to fit the antenna to the
rear or side window. Please keep in mind a heated rear screen could affect
the performance or reception.
u Check the cable length to ensure the connector can reach the
DAB/DAB+ receiver.
When fitting to the windscreen ensure that the area is clean and dry. Position
u
the antenna so it does not obstruct the drivers view of the road.
We recommended fitting the antenna to the passenger side vertically
150mm from the top of the windscreen (see diagram below)
u Attach the adhesive tab to a metal fixing point on A-pillar.
u To prevent damage to the ADI-300, if not using the antenna provided only use
an active antenna that is powered via the coaxial cable.
P
Position of the ADI-300 Digital Radio Adapter
The receiver can be mounted using the provided magnetic air vent holder or using
the flexi 12v power socket Adapter.
u Install in a location that is clearly visible and allows access for usability
u Install in a location that does no cause an obstruction to other functions
within the vehicle.
6
O