Sunbeam 1629-020 Manuel D'instructions page 3

H D
AIR RYER
Plug-In Model 1629-020
Hardwire Model 1629-040
Wall Mounted
Base Unit
Night Light
Switch
Clock
Handset Cord
Retract Button
1629-020
Only
1. Attractive Wall-Mount Design
2. Retractable Handset Cord
3. Ergonomic Handset with Auto-On
Switch
4. Button Free Handset Securing
5. Three Power Settings –
1500-Watt Max.
6. Cool Shot On All Settings
7. Night Light with On/Off Switch
8. Clock
F
EATURES
Inlet Vent
Ergonomic
Handset with
Retractable Cord
Auto On/Off
Switch
Cool Shot
ALCI
Safety Device
Night Light
(Underneath)
9. ALCI Safety Device
10. Removable Inlet Screen for
Easy Cleaning
11. Easy-Mount Wall Bracket Design
12. Convenient Wiring Options:
Plug-In (1629-020) or
Hardwire (1629-040)
13. Flame Resistant Plastic
14. UL Listed
15. One-Year Warranty
4
This dryer is equipped with an Appliance Leakage Current Interrupter (ALCI) for your
safety. This device is designed to make the appliance inoperable under some abnormal
conditions (such as accidental immersion in grounded water).
After the appliance is plugged in, you must check your protective device as follows:
with Lint
1. Press the "Reset" button on the ALCI device.
Screen
2. Press the "Test" button. The "Reset" button will pop out. This verifies that the
protective device is working properly.
3. Press the "Reset" button once more to reactivate the safety device and use
your appliance.
REPEAT THE ABOVE PROCEDURE BEFORE EACH USE TO CONFIRM
THAT THE PROTECTIVE DEVICE IS OPERATING.
If your protective device does not operate as described above, please contact your
Authorized Sunbeam dealer.
For your protection, this unit contains a thermostat that prevents the dryer from overheating.
Should the air intake and/or air outlet become blocked or obstructed, the hair dryer will
Power
automatically shut off. If this occurs, slide the switch to "OFF," unplug and allow dryer
Setting
Switch
to cool. If dryer continues to turn off automatically, discontinue use and contact your
Authorized Sunbeam distributor.
T U
O SE
1. Remove handset from base unit and pull handset cord to desired length – max length
is 5.5 feet.
2. Hair dryer will turn-on automatically when the on/off button on the handle is pressed
and held.
3. When finished, return handset to base unit.
4. Press cord retract button to retract cord into base unit.
C F
ONTROL EATURES
a. Power settings:
• Low – low air, low heat
• Medium – high air, medium heat
• High – high air, high heat
b. COOL SHOT on all power settings – eliminates heat
c. Retractable cord button
d. Night light switch
C
AUTION
Use your Sunbeam hair dryer with care. Directing a high volume of heat continuously to
one area can overheat hair and scalp. When using a "HIGH" heat setting, hold the blower
opening a few inches away from the hair, drying one section at a time. Work layers of hair
in quick strokes. Keep the dryer in motion until drying and styling are complete. .
O I
PERATING NSTRUCTIONS
:
5