AUTO-HAK JP05 Mode D'emploi page 4

FITTING INSTRUCTION
M10x40
1
D
B
This towing hitch is designed to assembly in following car:
JEEP WRANGLER (TJ), produced since 08.1996 till 03.2007, catalogue
no. JP 05 and is prepared to tow trailers max total weight up to 2000 kg
and max vertical load 80kg.
Thank you for buying our product. This towing hitch is design according
to rules of safety traffic regulations and their reliability has been confirmed in
many tests. Reliability of towing hitch also depends on correct assembly and
correct exploitation. For this reasons we kindly ask to read carefully this
instruction and apply to hints.
The towing hitch should be install in places described by a car producer.
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
C
1998>>M12x40
<<1998 7/16˝x2.5˝ UNC
1998>>M12x40
<<1998 7/16˝x2.5˝ UNC
M12x75
A
C
Foreword
1. From the left chassis member unscrew original tow handle. From the
left chassis member unscrew bumper bolt. Next in this places fix
elements pos. C using bolts as shown in the drawing.
2. Put main bar of towing hitch (pos. A) to chassis member (holes pos. 1
must agree to original holes) and fix using elements pos. D.
3. Fix tow-ball (pos. B) and socket plate using bolts M12x75mm from
equipment.
4. Tighten all bolts according to the torque shown in the table.
D 5. Connect electric wires of 7-poles socket according to the instruction of
the car. (Recommend to make at authorized service station).
1
6. Complete the paint coating damaged during instalment.
M10x40
M10x30
After install the towing hitch you should get adequate note in registration
book (at authorised service station). The car should be equipped with:
Indicators
Tow mirrors
After 1000km check all bolts and nuts. The ball of towing hitch must be
always kept clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M 8 25 Nm M 10 55 Nm
M 12 85 Nm M 14 135 Nm
NOTE