Gorenje IMC 1200B Notice D'utilisation page 23

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 60
To restart the appliance, remove the ice basket and
add water up to the MAX sign and press POWER.
Depending
on
environment and water, the first ice cubes may
be smaller.
Due to rapid freezing of the water, the cubes
may appear cloudy, or opaque. This is a result
of the air trapped inside the ice and it does not
affect the quality of the ice.
After the appliance has been switched to
standby mode, wait for at least 3 minutes
before starting its operation. Failure to do so
may result in compressor failure.
Replace the water in the water tank at least every
24 hours.
To prevent the development of mould and bacteria,
we recommend leaving the cover open after use
(7).
Cleaning
Before cleaning the appliance, stop its operation
and disconnect it from the power mains.
Do not clean the appliance with scouring pads,
caustic or corrosive cleaners or aggressive liquids
like alcohol, gasoline, or acetone.
Clean the appliance with a soft damp cloth. Do not
submerge the unit in water and do not clean it under
running water or in a dishwasher.
Ice basket: Clean the basket with lukewarm water
and some liquid detergent; then rinse and dry
thoroughly.
Water tank: Use the drain (11) to empty the water
tank.
Appliance interior and exterior (housing): Clean the
appliance interior and exterior with a soft damp
cloth. A diluted mixture of water and vinegar may
be used.
Trouble shooting
Trouble
Possible
reason
The indicator
There is no
above the
voltage in
POWER
the power
button will not
mains.
light up.
The
appliance is
not
connected to
the power
mains.
the
temperature
Solution
1. Check if there is
voltage in the power
mains.
2. Connect the appliance
to the power mains.
3. Internal appliance
components have
failed. Call Gorenje's
customer service.
Indicator
above the ICE
FULL sign is
of
the
on.
Indicator
above the
ADD WATER
sign is on.
All indicators
are flashing.
Although the
ice basket is
full, the ICE
FULL indicator
will not light up
and the
appliance will
not switch off.
Environment
After the expiry of its useful life, do not discard the
appliance with common household waste. Take is to an
authorized recycling centre. This will help preserve the
environment.
Warranty and repair:
For more information or in case of problems, please visit
Gorenje website at www.gorenje.com or contact Gorenje
customer service in your country (phone numbers are
listed in the International Warranty Sheet). If there is no
such centre in your country, please contact the local
Gorenje dealer or Gorenje's small domestic appliance and
personal care appliance department.
For personal use only!
GORENJE
WISHES YOU A LOT OF PLEASURE IN
USING YOUR APPLIANCE.
We reserve the right to modifications.
20
Ice basket is
1. Remove the ice from
full.
the basket.
2. Internal appliance
components have
failed. Call Gorenje's
customer service.
There is not
1. Add water up to the
enough
MAX sign and press
water in the
the POWER button.
water tank.
2. Internal appliance
components have
failed. Call Gorenje's
customer service.
Ice is
1. Switch the appliance
preventing
to standby mode and
the water
remove the ice cubes
tank from
blocking the water
moving.
tank.
2. Internal appliance
components have
failed. Call Gorenje's
customer service.
The sensors
1. Disconnect the
only start to
appliance from the
operate after
power mains. Empty
three
the ice basket and
finished
reconnect the
cycles.
appliance after 3
There is no
minutes.
signal for the
2. Powerful light is
sensor.
disturbing the signal
reception Move the
appliance away from
the source of light.
3. Internal appliance
components have
failed. Call Gorenje's
customer service.

Publicité

Table des Matières
loading

Table des Matières