Installation; Pre-Configuration; Standalone Splitter - Installation - Belkin OmniView ExpandView Serie Manuel De L'utilisateur

Installation

Pre-Configuration

The enclosure of the Splitter is designed for a standalone or
multiple-splitter configuration.
Consider the following when deciding where to place your Splitter:
• The location of your monitors
• The lengths of the cables you use
to connect your monitors to the Splitter
• The location of your computer
• The lengths of the cables you use
to connect your computer to the Splitter
• Number of splitters you wish to use
Cable Distance Recommendations
We recommend that the video cable length be limited to 30 feet for
best video performance. Beyond that length, lower video resolutions are
recommended.
6-7
6
Installation
Standalone Splitter – Installation
This section provides complete instruction for the hardware setup
of a single splitter configuration.
Powering On the Splitter
1.
Connect the included 9V DC, 1.5A power supply to an available
power outlet.
2.
Attach the barrel plug into the power jack of the Splitter.
VIDEO IN
VGA IN
VGA 8 VGA 7 VGA 6
VIDEO OUT
VIDEO IN
VIDEO IN
VIDEO OUT VGA 4 VGA 3 VGA 2
VGA 5 VGA 4 VGA 3 VGA 2 VGA 1
VGA 1
7
15/11/04 3:02:55 pm