Mobile Home Installation; Unpacking - Frigidaire GLGH1642FS0 Instructions D'installation

MOBILE HOME INSTALLATION

1. Dryer MUST be exhausted outside (outdoors, not
beneath the mobile home) using metal ducting
that will not support combustion. Metal ducting
must be 4 inches (10.16 cm) in diameter with no
obstructions. Rigid metal duct is preferred.
2. If dryer is exhausted through the floor and area
beneath the mobile home is enclosed, the exhaust
system MUST terminate outside the enclosure
with the termination securely fastened to the
mobile home structure.
3. Refer to page 3 for other important venting
requirements.
4. When installing a gas dryer into a mobile home,
a provision must be made for outside make up
air. This provision is to be not less than twice the
area of thedryer exhaust outlet.
5.Installation MUST conform to current
Manufactured Home Construction & Safety
Standard (which is a Federal Regulation Title 24
CFR-Part 32-80) or when such standard is not
applicable, with American National Standard for
Mobile Homes. In Canada, the CSA Z240 is
applicable.
1234546 1234546
1234546 1234546
The laundry center is designed
under ANSI Z 21.5.1 for HOME
USE only.

UNPACKING

1. Using the four shipping carton corner posts (two on each side), carefully
lay the laundry center on its left side and remove the foam shipping
base.
1234567 Excessive weight. Use two or more people to
move Laundry Center.
2. Return laundry center to an upright position.
3. Remove the following from
the back side of the washer:
4 bolts,
4 yellow plastic spacers,
3 metal "P" clamps.
4. Remove the service panel
from the front of the washer.
5. Remove the 4 nuts and 6 large
washers that attach the 2
yellow shipping braces to the
drum and the base. Lift up
on the drum and remove the
braces (a yellow ribbon
surrounds the items to be
removed).
6. Remove the large styrofoam
block located under the
drum. Lift up on the drum, tilt
the base of the foam block
inwards toward the rear of the
washer until free, then pull
it out.
7. Remove and discard the
yellow ribbon and label from
the front of the washer.
8. Replace the service panel and
screws.
9. Carefully move the laundry
center to within 4 feet (1.22m)
of the final location to begin
the installation.
NOTE: If the laundry center is
to be transported at a later
date, the shipping support
hardware must be reinstalled
to prevent shipping damage.
7
SHIPPIN G CARTON CORNER POSTS
FOAM
SHIPPING
P AD
3
BOLT
3
SPACER
"P" CLAMP
5
4
8
7
5
6