tiko Energy Solutions tiko Meter Aramis Mode D'emploi page 7

Meter User's Manual
LED Explanation
The Meter features two LEDs: a red LED at the top, and a green LED at the bottom.
• In normal operation:
#
Top LED
Bottom LED
•
In firmware upgrade mode:
#
Top LED
Bottom LED
Step 1 Remove power from the electrical panel.
Step 2 Remove the cover panel. Unwire and remove the device. If another de-
vice of the installation is remaining, use the covers B and C to close the
openings (IMAGE 7).
Step 3 Put the cover panel back. Ensure that no electrical contact can be
touched.
Step 4 Power on the system.
Step 5 If the device remains property of tiko Energy Solutions AG or
its authorized reseller, it must be returned. Otherwise, the
ultimate disposal of a device shall be handled according to
national laws and regulations.
tiko Energy Solutions AG
Color
Steady Green
Steady Read
Color
Steady Green
Blinks Red @
0.5 Hz
English
Status
Operational
Device POST failure
Status
Device is running a
firmware upgrade
Uninstalling
Notes
Device Power-On Self-Test has
failed. Device requires service.
Notes
One blink each 2 seconds.
IM-0007-0003 Rev. 6
7 / 44