Masonry Drill Bits - DRILL DOCTOR XP Mode D'emploi

Masonry Drill Bits

To sharpen a masonry bit, you do not turn the chuck. Instead you
insert the chuck until it touches the wheel, remove, and repeat on
the other side.
1.
Masonry
Sharpening
Marks
2.
54
Align the bit with the
Masonry Sharpening
Marks
Insert the bit into the Chuck and line
up the carbide insert on the tip of the
bit so that it is parallel to the Ma-
sonry Sharpening Marks on the end
of the chuck. Leave about 1/2"–5/8"
of bit sticking out past the nose of the
Chuck. Tighten the Chuck just to the
point where the bit slides in and out.
Set the depth
Sharpening Guide
Cam Guide
Sharpening Port
the Chuck to ensure the insert
is aligned with the Masonry Sharpen-
ing Marks and tighten again.
Set the depth by lin-
ing up the Sharpen-
ing Guide with the
Cam Guide. Making
sure the Cam stays
against Cam Guide,
push the Chuck into
the Sharpening Port
until it stops and tight-
en the Chuck. Remove
www.drilldoctor.de