Germania BSM9N Manuel D'utilisation page 20

GB
Reduced flame gas cock adjustment
1. Please use driver with special head for removed and install nozzle as
(figure 3).
2. Please remove nozzle (figure 4) from burner with special nozzle driver
and install new nozzle. (figure 5)
Figure 3
Ventilation of room
The air needed for burning is received from room air and the gases emitted
are given directly in room. For safe operation of your product, good room
ventilation is a precondition. If no window or room to be utilized for room
ventilation is available, additional ventilation should be installed. However,
room has a door opening outside, it is no needed to vent holes.
Smaller than 5 m³
Between 5 m³ - 10 m³
Bigger than 10 m³
In basement or cellar
Reduced gas flow rate setting for hob taps
1. Ignite the burner that is to be adjustment and turn the knob to the
reduced position.
2. Remove the knob from the gas tap.
3. Use an appropriately sized screwdriver to adjust the flow rate
adjustment screw. For LPG (butane-pro pane) turn the screw clockwise.
For the naturel gas, you should turn the screw counter- clockwise once.
"The normal length of a straight flame in the reduced position should
be 6-7 mm."
4. If the flame is higher then the desired position, turn the screw
clockwise. If it is smaller turn anticolockwise.
Room size
Figure 4
20
Figure 5
Ventilating opening
min. 100 cm²
min. 50 cm²
no need
min. 65 cm²