Fcc Compliance - Serene HD 60J Manuel De L'utilisateur

FCC Compliance

This equipment complies with Part 68 of the FCC
Rules. On the equipment is a label that contains,
among other information, the FCC registration
number and ringer equivalence number (REN)
for this equipment. If requested; this information
must be provided to your telephone company.
This equipment uses the following Universal Service
Order Codes ("USOC") jacks: RJ-11. Connection
to the telephone network should be made by using
standard modular telephone jack type RJ11.
The REN is useful to determine the quantity of
devices you may connect to your telephone line
and still have all of those devices ring when your
telephone number is called. In most, but not all
areas, the sum of the RENs of all devices connected
to one line should not exceed five (5.0). To be
certain of the number of devices you may connect
to your line, as determined by the REN, you
should contact your local telephone company to
determine the maximum REN for your calling area.
If your telephone equipment causes harm to
the telephone network, the telephone company
may discontinue your service temporarily. If
possible, they will notify you in advance. But if
advance notice is not practical, you will be notified
as soon as possible. You will be informed of
your right to file a complaint with the FCC.
14
Your telephone company may make changes in
its facilities, equipment, operations or procedures
that could affect the proper functioning of
your equipment. If they do, you will be notified
in advance to give you an opportunity to
maintain uninterrupted telephone service.
In the event this equipment should fail to operate
properly, disconnect the unit from the telephone
line. Try using another FCC approved telephone
in the same telephone jack. If the trouble persists,
call the telephone company repair service bureau.
If the trouble does not persist and appears to be with
this unit, disconnect the unit from the telephone line
and discontinue use of the unit until it is repaired.
For repair or warranty information, please contact
Serene Innovations, Inc. at 562- 407 5400. Please
note that the telephone company may ask that you
disconnect this equipment from the telephone network
until the problem has been corrected or until you're
sure that the equipment is not malfunctioning.
There are no user serviceable parts in this equipment.
This equipment may not be used on coin
service provided by the telephone company.
Connection to party lines is subject to state
tariffs. Contact the state public utility commission,
public service commission for information.
If your home has specialty wired alarm equipment
connected to the telephone line, ensure the
installation of this equipment does not disable
your alarm equipment. If you have questions
about what will disable alarm equipment, consult
your telephone company or a qualified installer.
This equipment is hearing aid compatible.
This device complies with Part 15 of FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference
received, including interference that
may cause undesired operation.
Operating Environment for Home or Office Use
Notice: This equipment has been tested and found
to comply with the limits of a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation, if this equipment does cause
harmful interference to radio or television reception,