Table des Matières
Publicité
Range of functions of the remote
control
7
1. Aerial
2. Power (ON / OFF)
3. Control LED
4. Gas
Circling
5. Forwards / backwards
right / left banking
6. Trimmer for right / left banking
7. Trimmer for forwards / backwards
8. Trimmer for rotation
9. Looping Button
10. Headless Mode
11. Start rotor' button
12. 'Auto-landing' button
13. 'Auto-start & fly to 1.5 m' button
14. Light (on/off)
15. Beginner/Advanced switch
(30%/60%/100%)
3
16. Battery compartment
Choosing the flight area
When being prepared for the first flight
8
you should choose a closed room
which is as large as possible without
any persons or obstacles. Due to its
size and controllability, experienced pi-
lots may be able to fly the Quadrocop-
ter in relatively small rooms. For your
first flights we strongly recommend
you choose a room with a minimum
floor space of 5 x 5 metres and 2.40
metres in height. After having trimmed
your Quadrocopter for flight and made
yourself familiar with the controller and
its functions you may start flying in
smaller and less open environments.
To be used in domestic area (house and
garden) only.
There must be no persons
or objects such as pillars between the con-
troller and the Quadrocopter to obstruct
direct connection.
ENGLISH
Checklist for flight preparation
This checklist is not a substitute for the con-
tents of the operating instructions. Although it
can be used as a quick-start-guide, we strong-
ly recommend you first to read the operating
instructions in detail before you proceed.
• Check the contents of the package.
• Connect the charging unit to the source of
power.
• Charge the lipo-battery as described in the
section "Recharging the LiPo rechargeable
battery".
• Fit 2 AA batteries in the controller, making
sure their polarity is correct.
• Look for a suitable environment for flying.
• Read and comply with the legal and safe-
ty regulations governing the use of your
Quadrocopters.
• Slide the battery into the battery bay on the
bottom of the Quadrocopter.
• Connect the battery in the model.
• WARNING! Immediately after switching it
on, place the Quadrocopter on a flat and
level surface. The gyro-system will then
set itself automatically.
• The LEDs on the quadrocopter flash.
• Switch on the controller at the ON/OFF
switch. Be sure to check the Beginner-Ad-
vanced switch (
joystick, i.e., the throttle control, completely
upwards and then completely downwards.
• Allow the Quadrocopter a few moments un-
til the system is correctly initialised and is
ready for operation. The LED in the Quadro-
copter now lights continuously. The LED on
the controller now lights continuously.
• Repeat the above points as required, if you
wish to fly more Quadrocopters at the same
time.
• Important note! Please perform the au-
to-trimming
17
fail!
• Press the 'Start rotors' button.
• Check the control system.
• Make yourself familiar with the control system.
• Trim the Quadrocopter as necessary
as described under
20
2b
). Push the left-hand
13c
before each flight without
, so that
17
18 19 20
Publicité
Table des Matières
