Troubleshooting; Cleaning And Care - Klarstein BERETTA Mode D'emploi

TROUBLESHOOTING

Problem
The light goes on but the motor
does not run.
The light and the motor are not
working.
The light does not work.
Unsatisfactory exhaust
performance.
The hood is hanging awry.

CLEANING AND CARE

Before servicing or cleaning, the cooker hood should always be disconnected from
the power supply. Make sure the cooker hood is off and the plug has been removed.
External surfaces are prone to scratches and dents, so follow the cleaning instructions to
get the best results without damage.
General
Allow the unit to cool completely before cleaning and caring for the device, and do not
use alkaline or acidic substances such as lemon juice or vinegar to clean the surface.
Stainless steel
The stainless steel must be cleaned regularly (weekly) to ensure a long service life. For
this, a special stainless steel cleaning fluid may be used.
Possible cause
The motor is switched off.
The motor switch is broken.
The motor is broken.
Your house fuse is flipped or
broken.
The power cord is loose or not
connected.
The light is broken.
The distance between the
stove and extractor hood is
too great.
One of the fixing screws is not
tightened properly.
Solution
Switch on the motor with the
SPEED button.
Contact a specialist.
Contact a specialist.
Replace the fuse switch or
replace the fuse.
Connect the power cord
properly.
Replace the bulb.
Reduce the distance.
Tighten the screw properly.
EN
29