Intersun LOLITE Notice De Pose page 25

Table des Matières

Publicité

Suppression de la mémoire radio. Télécommande + Capteur Clim.
1 - Maintenir appuyer « MENU » pendant 5s
(jusqu'à ce que «MConF» s'affiche).
3s
3 - Maintenir appuyer « MENU » pen-
dant 3s. L'écran clignote.
Réinitialiser l' Automatisme en mode usine.
1 - Maintenir appuyer « MENU » pendant 5s
(jusqu'à ce que «ConF» s'affiche).
3s
3 - Maintenir appuyer « MENU » pen-
dant 3s. L'écran clignote.
5s
4 - Maintenir Appuyer 1x «MENU»
jusqu'à la fin du décompte.
5s
4 - Maintenir Appuyer 1x «MENU»
jusqu'à la fin du décompte.
DISPLAY
Moteur en position OUVERTE

Moteur en position FERMÉE

Manutention en ouverture

Manutention à la fermeture

Arrêt en position intermédiaire lors de l'ouverture

Arrêt en position intermédiaire pendant la

fermeture
Moteur 2 non utilisé ()

Moteur 2 synchronisé avec le Moteur 1 ()

DISPLAY
Surintensité en position intermédiaire (c.-à-d.

obstacle).
Pas de courant moteur en position intermédiaire.

Position finale non atteinte.

Court-circuit du moteur.

Sous-tension.

Restauration du système avec succès après une

baisse de tension d'alimentation. Aucune action
nécessaire.
La restauration du système a échoué après une

baisse de tension d'alimentation. Vous devez
redémarrer le module.
2 - Appuyer 1x «DOWN» pour atteindre «rAdEF».
1x
2 - Appuyer 1x «DOWN» pour atteindre «ctdEF».
INDICATIONS À L'ÉCRAN
1x
INFORMATION ON THE DISPLAY
DESCRIPTION
INDICATIONS À L'ÉCRAN
INFORMATION ON THE DISPLAY
DESCRIPTION
2x
5 - «donE» Suppression validé.
1x
5 - «donE» Suppression validé.
Motor in OPEN position
Motor in CLOSE position
Handling in opening
Handling in closing
Intermediate stop during opening
Intermediate stop during closing
Motor 2 not used ()
Motor 2 synchronised to Motor 1 ()
Overcurrent in intermediate position (i.e. obstacle).
No motor current in intermediate position.
Final position not reached.
Motor short circuit.
Undervoltage.
System restore successfully after a power outage.
No action needed.
System restore not successfully performed after a
power failure. It is necessary to restart the Control
Unit.
Page 25

Publicité

Table des Matières
loading

Table des Matières