Before Startup; Start Up; Electrical Connection - Kärcher HD 10/25 S Mode D'emploi

Before Startup

Unpacking
Check the contents of the pack be-
–
fore unpacking.
In case of transport damage inform
–
vendor immediately
Check oil level
Read the oil level display when the

device is not running. The oil level
must be above the two pointers.
Activate deaeration of oil con-
tainer
Unscrew the fastening screws of

the device hood; remove the device
hood.
Cut off tip of oil container cover

Fasten the device hood.

Install hand spray gun, spray
lance and nozzle
1.
Mount the nozzle on the spray pipe

(markings on the adjustment ring at
the top).
Connect ray tube to hand spray gun

Tighten the screw connection of the

spray lance finger tight.
Lock in the cable hook in the side-

hole on the handle.
Tighten the high-pressure connec-

tion as required.
2.
– 5
EN

Start up

Electrical connection

Danger
Danger of injury by electric shock.
The appliance may only be connected
to alternating current.
The appliance may only be connected
to an electrical supply which has been
installed in accordance with IEC
60364.
The voltage indicated on the type plate
must correspond to the voltage of the
electrical source.
The minimum fuse rating required at
the socket outlet is (see technical
specifications).
The highest allowed net impedance at
the electrical connection point (refer to
technical data) is not to be exceeded.
In case of confusion regarding the
power impedance present on your con-
nection, please contact your utilities
provider.
The appliance should always be con-
nected to the electrical mains using a
plug. It is forbidden to permanently
connect the appliance to the power
supply. The plug is only for mains sep-
aration.
Check the power cord with mains plug
for damage before every use. If the
power cord is damaged, please ar-
range immediately for the exchange by
an authorized customer service or a
skilled electrician.
The plug and coupling of the extension
cable used must be watertight.
Use the extension cord that has an ad-
equate cross-section (see "Technical
Data") and unwind it fully from the ca-
ble drum.
Unsuitable extension cables can be
hazardous. Only use extension cables
7