Tools Required - Octane Fitness CROSS CiRCUIT PRO KIT Instructions De Montage Et Mode D'emploi

Kit Contents
 Left Side Weight Stand with Foot Platform
 Right Side Weight Stand with Foot Platform
 Assembly and Safety Instructions
 Hardware Kit (see illustration)

Tools Required

 4mm hex key wrench (included)
 17mm drive socket, wrench and extension
 8mm wrench
Assembly Instructions
 Pull off rear plastic cover.
 Remove side track cover with
4mm hex key wrench.
 Remove rear leveler.
 Fasten weight stand to machine
with bolt A (Qty 2), nut C (Qty 2),
lock washer B (Qty 2), and flat
washer D (Qty 4). Tighten to 30
ft-lbs.
 Replace rear leveler and tighten
by hand.
Repeat  -  for other side.
CROSS CiRCUIT PRO KIT











ENG-1