Mounting A Prcab Cabinet - INIM Electronics PREVIDIA MAX PRCAB Manuel D'instructions

3

Mounting a PRCAB cabinet

1. Remove the securing screws and door (paragraph 2 - [D]).
2. Remove the front-plate grounding conductor (paragraph 2 - [C]) and, if present, the CAN wire.
3. Push the hinge grips, located at the top and bottom of the door hinges, inwards (paragraph 2 - [E]) to
release the cabinet front plate.
4. Remove the seals from the cable entries you intend using (paragraph 2 - [I]).
Nota:
In order to guarantee the IP30 protection grade, do no remove any other seals.
5. Pull the cables through the open cable entries.
6. By means of the holes on the back of the cabinet, mount it to the wall (paragraph 2 - [G]).
Use anchor screws (stop screws) with 8mm diameter minimum.
7. Insert and secure the various modules inside the cabinet and on the front plate.
8. Replace the front plate and reconnect the grounding conductor and CAN wire.
9. Complete the wiring of the internal modules.
4 Affixing cabinets to one another
Refer to Figure 1 - PRCAB - a, page 20.
The cabinets can be attached together by aligning the bottom of one cabinet with the top of another.
This operation allows you to join together up to 4 cabinets.
1. Remove all modules and wire/cables from the cabinets,
2. Remove the seals from holes used for affixing cabinets together.
3. Align the cabinets and, using the bolts (supplied with each cabinet), secure them together (paragraph 2 - [H]).
4. Connect the CAN drive bars of each cabinet together using the CAN wire (supplied with each cabinet).
5. Install the necessary modules and proceed with the installation of the control panel.
5 Multi-PRCAB cabinet wiring
Refer to Figure 2 - PRCAB - b, page 20.
Once the cabinets are affixed to one another, the CAN drive bars of each cabinet ([A], [B], paragraph 2 - [J])
must be connected together. To connect the CAN drive bars, use the BUS cable supplied with every PRCAB [C].
The two wires of this cable must be inserted, one into the lower connector of the CAN drive bar of the cabinet
above ([D], paragraph 2 - [Q]), and the other into the upper connector of the CAN drive bar of the cabinet
below ([E], paragraph 2 - [O]).
In the same way, it is convenient to connect the grounding wires of the cabinets that are attached together.
For this purpose, use the proper cable supplied with every PRCAB [F] and connect to each other the grounding
bars of the two adjacent cabinets ([G], paragraph 2 - [L]).
6
PRACAB - technical specifications
Dimensions
Weight
Protection rating
Accepted Batteries
433 x 563 x 187 mm
10Kg
IP30
2 x 12V 24Ah, NPL24-12I or equivalent or
2 x 12V 17 Ah, NP 17 -12-FR or equivalent
PRCAB