General Description - INIM Electronics PREVIDIA MAX PRCAB Manuel D'instructions

Installation manual
1 About this manual
Manual code: DCMIIN1PPRCAB
Version: 1.30
2

General Description

The PRCAB cabinet is a metal enclosure equipped with a front plate (door) with removable hinges. The cabinet
can be wall mounted and anchored in place using the holes on the back of the enclosure or can be affixed to
another cabinet by means of two bolts and the holes on the top and bottom sides of the enclosure.
The front of the cabinet provides two apertures for mounting two FPM front-plate modules and the grounding
connections.
It has a compartment for the connection of up to 8 IFM modules via a CAN drive bar equipped with connectors
for IFM internal modules, and a CAN BUS cable for communication with the FPM front-plate modules or affixed
cabinets. The compartment has a bar which serves to hold the modules in place and allows the grounding
connections. There is a placement for two 12V, 24Ah or 17Ah batteries.
The cabinet has hooks for the cable ties and cable entries on the top and bottom sides. Appropriate hole
covers are provided.
The cabinet is also available in red and can be ordered using the following code: PRCAB-R.
The available accessory items, required in accordance with the type of installation, are as follows:
• PRCABSP kit for mounting the cabinet at a distance of 5cm from the wall, also available in red (PRCABSP-R)
• PRCABRK kit for mounting the cabinet to a rack, also available in red (PRCABRK-R)
PRCAB comes with:
• CAN drive bar (inserted)
• Hole covers (inserted)
• 2 bolts for affixing cabinets together
• CAN BUS cable
• Ground connection wire
• Instructions manual
[A]
[B]
Apertures for FPM front-plate modules
Soldered connectors for the front plate and
[C]
FPMCPU module grounding connections
[D]
Screw locations for the cover screws
[E]
[F]
[G]
Wall-mount screw locations
[H]
Bolt holes for affixing cabinets together
[I]
[J]
Figure 1 - Parts, page 1
Front plate
Hinge grip
Back
Cable entry
CAN drive bar
[K]
Compartment for internal modules
[L]
Earth connection bar
[M]
Backup battery housing
[N]
[O]
to the CAN drive bar of an upper cabinet
CAN
[P]
connector
[Q]
to the CAN drive bar of a lower cabinet
to the power-supply module, if present
[R]
Connector for
IFM internal
for all modules except the power supply
module
[S]
PCB CAN drive
to the module on the front plate
or any module
module
5