Grundig MC 3320 Mode D'emploi page 19

SAFETY­AND­SET-UP
▪ To realign the blades, simply match the
upper and bottom blades teeth up, point
for point. (End of top blade teeth should be
approximately 1.2mm back from bottom
blade. Compare your clipper blades with
the sketch.)
▪ If blade alignment is incorrect, add a few
drops of oil to the blades, turn clipper on
for a few moments, turn off and unplug.
Loosen screws slightly and adjust. Tighten
screws after blade is aligned.
▪ To maintain your clipper in peak condition,
the blades should be oiled every few hair-
cuts.
▪ Do not use hair oil, grease, oil mixed with
kerosene or any solvent. As the solvent will
evaporate and leave the thick oil which
may slow down the blades motion.
­ ____________________________
ENGLISH 19­