Berger & Schroter SG880MK-8mHD Mode D'emploi page 33

PIR Trigger
PIR-Interval
Work Hour
Choose sensitivity of the PIR sensor.
This parameter defines the sensitivity of the PIR.
There are four sensitivity parameters: High, Normal,
Low and Off. The default value is "Normal". The
higher degree indicates that the Camera is more
easily to be triggered by motion, taking more
pictures or recording more videos. It is
recommended to use high sensitivity degree in room
or environment with little interference, and to use
lower sensitivity for outdoor or environment with lots
of interference like hot wind, smoke, near window
etc. Furthermore, the sensitivity of the PIR is
strongly related to the temperature. Higher
temperature leads to lower sensitivity. Therefore it is
suggested to set a higher sensitivity for high
temperature environment.
This parameter indicates how long the PIR (Passive
Infrared motion sensor) will be disabled after each
triggering in ON mode. During this time the PIR of
the device will not react to the motion of human (or
animals). The minimum interval is 0 second, it
means the PIR works all the time. The maximum
interval is 1 hour. It means the PIR will be disabled
for 1 hour after each triggering. Press LEFT or
RIGHT to decrease or increase the value.
Choose a time period of a day to let the camera
work. The camera will awake at the setting time
duration in a day. In the rest of the time the camera
is sleeping. Set Work Hour as off means the camera
works all day.
33