Before Connecting The Dvd-Vcr; Connection To A Tv (Video); Connection To A Tv (S-Video) - Samsung DVD-V6700 Manuel D'instructions

Before Connecting the DVD-VCR

- Always turn off the DVD-VCR, TV, and other components before you connect or disconnect any cables.
- Refer to the user's manual of the additional components (such as a TV) you are connecting for more
information on those particular components.
Connection to a TV
The following shows examples of connections commonly used to connect the DVD-VCR with a
components.
Connection to a TV
1
Using video/audio cables, connect the VIDEO
(yellow)/AUDIO (red and white) OUT
on the rear of the DVD-VCR to the
(yellow)/AUDIO (red and white)
your TV.
2
Turn on the DVD-VCR and TV.
3
Press the input selector on your
control until the Video signal from the DVD-VCR
appears on the TV screen.
Notes
- Noise may be generated if the audio cable is placed too close to the power cable.
- If you want to connect to an Amplifier, please refer to the Amplifier connection page.
(See pages 19 to 20).
- The number and position of terminals may vary depending on your TV set. Please refer to the user's manual
of your TV.
- If there is one audio input terminal on the TV, connect it to the LINE OUT AUDIO OUT Left (white) terminal of
the DVD-VCR.
- If you press the P.SCAN
mode changes in the following sequence: (S-Video - Interlace - Progressive)
C
O N N E C T I O N S
(Video)
terminals
VIDEO
IN terminals of
TV remote
button when DVD-VCR is in stop mode or no disc is inserted, the
Red
ENG-15
TV and other
White Yellow
Audio Cable
Red
Video Cable
White Yellow
Alt Video Out