Switch Off - 2GO 797301 Mode D'emploi

GB Operating instructions
We are pleased that you have chosen our product. Please take your time and read the user
manual to learn more about the features and notes of the headset. The Bluetooth headset can
be used with compatible devices that support Bluetooth wireless technology. This gives you
the ability to make any calls and use music streaming services at any time. Please read this
manual carefully before using this headset. Please refer to the user manual for information
about the Bluetooth function and observe important safety and care instructions. Keep out of
the reach of small children.
Pairing the headset with a Bluetooth phone
Make sure the headset is turned off and the distance between headset and phone is no more
than one metre. Then activate the Bluetooth function on the phone. Remove the two earpho-
nes from the charging box to turn them on. Wait for about 10 seconds - The earphones now
automatically pair with each other. Afterwards, the headset automatically switches to pairing
mode so that the connection to your mobile device can be established. Open your mobile
device's Bluetooth settings and search for new devices. Select "2GO Dynamic" to establish
the connection. If the Bluetooth connection to your phone has been interrupted, it will be
automatically restored when you turn the headset back on within the operating radius.
Should a connection error occur:
1. Turn off both earphones by placing them in the charging box and turn them on again.
2. If the earphones are outside the charging box, press and hold the touch buttons of the
earphones for 3 seconds.
So you reset the headset and it reconnects again.
Switch on
Open the lid of the charging box and remove the earphones from the charging box.

Switch off

Plug the headset into the charging box and close the box.
Charging mode
Charging the headset
Plug the earphones into the charging box and close it. The headset now automatically
recharges when the charging box is loaded.
Charging the charging box
Connect the included Micro-USB cable to the charging socket, charging box and a USB
charger or PC. After one hour, the headset is fully charged.
Operation during music playback
Increase volume 1 x right earphones briefly touch
Reduce volume
Break /Play
Previous song
Next song
Voice control
Enable voice control 3 x left earphones briefly touch
Initial call
Acceptance of calls left or right earphones briefly touch
Exit call
1 x left earphones briefly touch
2 x left or right earphones briefly touch
1 x left earphones longer touch
1 x right earphones longer touch
left or right earphones briefly touch