Planer Guard; Adjusting The Planer Depth Cut - Robland SD410 Mode D'emploi

Planer guard

The planer guard above the cutter block and the planer fence is the so-called " bridge type " , the
adjustment according to the workpiece is done manually.
The suspension system in the security ensures that, after the pressing down of the bridge to the table
surface, the bridge will automatically spring back up to the set height.
Place the bridge always about 10 mm above the table surface, so that the pusher can still be used, and
move the bridge so far sideways that only the workpiece can pass between the planer fence and the
bridge.
When planing, set the bridge to workpiece thickness using the knob.
Make sure the planer security always is in place at all planer operations,
and make sure that it is kept in good condition. If necessary, replace damaged parts of the safety
device.
Fig.7

Adjusting the planer depth cut

Unlock the clamping handle (1).
By lifting up or pushing down the lever (2)
the depth of cut can be adjusted. The depth of cut can be read at the scale (3).
After setting is done, lock the clamping handle (1).
The maximum depth of cut is 8 mm.
Fig.9
50
Nederlands Français
(Fig.7-8)
Fig.8
English Deutsch
(Fig.9)
V0114 SD410 - S410