Alarm.Com DSC iotega Guide D'installation page 2

Auto-Learn mode
Power up the sensor or device and trigger it according to the instructions in the
device manual. Enrolled devices are displayed on the Mobile Tech page in the
Added Devices section.
Once all devices are added, choose Exit.
Edit the device name, group, and partition as needed.
Click Save to finish.
Add Sensor and Peripheral Devices (Remote Add)
Enter the device ID, zone definition, partition, name, and ESN into the
appropriate fields.
Click Add Sensor to finish.
The device may need to be tampered when in range of the panel in order to
start functioning.
Confirm devices are enrolled
Navigate to Equipment and check the status of each device to confirm correct
operation.
Install devices in their final location around the home.
Complete a walk test
Navigate to Equipment > Perform Walk Test > Begin Walk Test. As devices are
triggered, the onboard siren sounds and a response is displayed on the page.
Perform a system check
Navigate to Remote Toolkit > Run System Check to confirm the system is
functioning properly. If an issue or trouble condition is present, select Review &
Troubleshoot for details.
The iotega Security System is now set up. You can add additional security
or Z-Wave devices via the installer portal and control the system from the end-
user mobile app and web portal.
For information on using the iotega and adding Z-Wave devices or
cameras, please refer to the online user manual.
For technical support
Access the "Support" tab on the Alarm.com Partner Portal to log a ticket or find
the phone number for your region.
For hardware technical support:
1(800) 378 3630 (U.S. & Canada); (905) 760 3000 (international)
Table 1-1 Trouble Indications
1 st Layer 2 nd Layer
00 Alarm.com Custom 01 Zwave Trouble
02 Image Sensor Radio
03 to 09 Trouble 3 to 9
01 System Trouble 01 AC
02 Battery Trouble
03 Tamper
04 Hardware Fault
06 RF Jam
02 Zone 01 AC Trouble
02 Battery Trouble
03 Tamper
04 Fault (Supervision)
05 Not Networked
06 Fire/CO Trouble
03 Siren 01 Future Use
02 Battery Trouble
03 Tamper
04 Fault (Supervision)
05 Not Networked
04 Keypad 01 AC
02 Battery Trouble
03 Tamper
04 Fault (Supervision)
05 Not Networked
05 Repeater 01 AC
02 Battery Trouble
03 Tamper
04 Fault (Supervision)
05 Not Networked
06 RF Jam
06 Wireless Key 01 Future Use
02 Battery Trouble
03 Future Use
04 Future Use
05 Not Networked
07 Communication 01 Receiver Unavailable
02 FTC Trouble
03 Receiver Supervision Trouble
04 Cellular Trouble
05 IP Network Trouble
3 rd Layer
1-128
1-128
1-128
1-128
1-128
1-128
1-16
1-16
1-16
1-16
1-16
1-9
1-9
1-9
1-9
1-9
1-8
1-8
1-8
1-8
1-8
1-8
1-32
1-32
1-32
1-32
1-32
receiver 1-4