Abus FUWM50000 Mode D'emploi page 14

surface, with the contacts for the water
sensor facing downwards.
Installation
Open the housing of the wireless
transmitter. Loosen the fastening screw on
the PCB, then lift the PCB carefully out of
the housing. Install the wireless transmitter
at the selected location. Screw the rear part
of the detector housing to the wall. Fasten
the PCB back into the housing, then insert
the lithium battery provided with the correct
polarity. Connect the cable of the water
sensor to the screw terminal of the
transmitter.
Fastening the water sensor:
Choose a location that will be flooded very
quickly in the event of water penetration.
Change the wireless transmitter settings as
required using the jumpers.
Setting possibilities
Jumper: Disable Tamp
The tamper contact on the detector is
inactive when this jumper is attached. You
can then open the detector housing without
triggering a tamper alarm.
Jumper: Disable View State
The LED lights up as soon as the sensor
detects water when this jumper is attached.
14