Stacking And Tilting The C Que 8 - Samson Audio C-que 8 Manuel Du Propriétaire

Stacking and Tilting the C que 8

Stacking the C que 8
You can stack one C cue 8,
or any other Samson C Class
units, on top of each other by
simply lining up the bumpers.
Important Note: When stacking
the C que 8, be sure that only
the bottom unit has the tilting
feet installed.
• Remove the bottom screw from right front bumper.
• Identify the right tilting foot by the locating "R" marking on the inside top.
• Position the angled foot under the right bumper as shown in the drawing.
Installing the Tilting Feet
�� �
����
��
You can install the tilting rubber feet included
�
with your C que 8 so that you can set the unit at a
�
��
����� ���
��� comfortable operating angle on a workstation or
���
desktop. Follow the simple instructions below to
����� ���
���
install the tilting feet.
���
�� �
�����
• Remove the bottom screw from right front
bumper.
• Identify the right tilting foot by the locat-
ing "R" marking on the inside top.
• Position the angled foot under the right
bumper as shown in the drawing.
• Use the included 3 x 16mm screw to attach
the foot.
• Repeat the steps above for the front left
bumper.
0
VOLUME
INJECT
0
VOLUME
INJECT
�� � �� �
��
�
� ��
��
������
���
���
���
� ��
������
CH 1
MAIN
OL
0
0 10
10 L R
-6 VOLUME
SHAPE OUT
BALANCE
-12
SHAPE OUT
-18
-24
0 10
CH 2
VOLUME
2 CH STEREO
CH 1
MAIN
OL
0
0 10
10 L R -6
VOLUME
SHAPE OUT
BALANCE
-12
SHAPE OUT
-18
-24
0 10
CH 2
VOLUME
2 CH STEREO
�� �
� ��
������
����� ���
����� ���
� ��
�� �
������
14
CH 3
CH 1 CH 2 CH 3 CH 4
OL OL
0 0
0 10
-6 VOLUME -6
SHAPE OUT
-12 -12
SHAPE OUT
-18 -18
-24 -24
0 10
CH 4
VOLUME
CH 3
CH 1 CH 2 CH 3 CH 4
OL OL
0 0
-6 0 10 -6
VOLUME
SHAPE OUT
-12 -12
SHAPE OUT
-18 -18
-24 -24
0 10
CH 4
VOLUME
�� � �� �
��
�
��
���
���
���
� �������
��������� ���
4 CHANNEL
HEADPHONE AMP
4 CHANNEL
HEADPHONE AMP