HeroCamper K2400-50 Guide D'installation Et Manuel D'utilisation page 15

Tips (continued)
10. To select the COOL mode, adjust the set point temperature to three
degrees lower than the room temperature, the unit will start to blow
cold air after the compressor starts – approximately 3 minutes.
11. To select the HEAT mode, adjust the setting temperature as three
degrees higher than the room temperature.
12. If you are not to use the air-conditioner for an extended period, please
isolate the power supply.
13. This appliance is not to be used by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they are under supervision.
14. The system is set automatically to monitor freezing of the evaporator,
If this happens the system will automatically start "Defrosting" process.
At first it will display "DF" on the display, then the 4-way valve will
change its flow direction for 1 minute and compressor will run 10
minutes, until the system detects there is no more frosting on the
evaporator. After this process is finished, the "DF" will disappear from
the display, and the unit will continue running.
Note: After selecting the COOL/HEAT mode, the
compressor will have a delay start for three minutes.
#HeroCamper™ – Lammefjordsvej 5 – 6715 Esbjerg N – Denmark
Phone +45 7022 5840 – sales@herocamper.com
www.herocamper.com
VAT No DK -40193189
14