Garland 790 G Manuel D'instructions page 23

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 38
- Only operate the machine in an open space and on
a fi rm, level surface.
- Only operate the machine with dry weather and,
never outside while it is raining.
- Never use the machine if the security system is
damaged or not working well.
- Do not let the machine unattended and turn off the
engine while you are not operating with it.
- If the cutting mechanism strikes any foreign objects
or if the machine should start making any unusual
noise or vibration, shut off the power source and
allow the machine to stop. Disconnect the spark
plug wire from the spark plug (electric unit
disconnect from supply).
- Do not let using the machine to anybody who has
never read the user manual or not has been
familiarised with it.
- Operate with the machine while there is a good
lightning conditions.
- If the machine starts vibrating in a different way as
usual, shut of the engine and verify the cause -
immediately. Vibration means another issues.
- Have any damaged parts replaced or repaired with
parts having equivalent specifi cations.
- This machine is not allowed to be used by people
(children) with physical, mental or sensorial
handicapped. Or if they do not have any knowledge
or experience.
- Use extra care in handling fuels. They are
fl ammable and the vapours are explosive.
- Use only an approved container.
- Never remove the fuel cap or add fuel with the
power source running. Allow engine and exhaust
components to cool before refuelling.
- Never refuel machine indoors.
- Do not smoke.
- Store the machine or fuel container inside where
there is an open fl ame, such as a water heater, far
from fl ammable things.
- If fuel is spilled, do not attempt to start the power
source, but move the machine away from the area
of spillage before starting.
- Always replace and securely tighten the fuel cap
after refuelling.
- If the fuel tank is drained, this should be done
outdoors.
- Never use your hands or metallic tools to push the
remains inside the hopper.
- Do not touch the muffl er or the exhaust because
they can have very high temperatures and you can
burn yourself.
- Do not leave any remainder on the discharge chute,
they can blockage the machine.
- Before start operating, check the wind direction to
not work face to the gases.
- Keep proper balance and footing at all times.
- Only operate the machine in open space (e.g. not
close to a wall or a fi xed object) and on a fi rm, level
surface.
- Do not operate the machine on a paved or gravel
surface where ejected material could cause injury.
English | 22

Publicité

Table des Matières
loading

Table des Matières