Measuring Method; Temperature Unit - saia-burgess CXM201 Mode D'emploi

5.4 Programmng the adjustable parameters
5.4.1 Input signal type
Selection in the menu

5.4.2 Measuring method

Selection in the menu
5.4.3 Decimal point
Selection in the menu
5.4.5 Correction value
Inputting a correction value allows acting upon the
displayed result. These correction values may be
Selection in the menu
16
Range
Pt100 probe
Ni100 probe
Measuring method
2 wires; please note
See point 5.4.2.1 opposite!
3 wires
4 wires
Decimal point
Resolution 0,1 °C/0,1 °F
Resolution 1 °C/1 °F
Setting the correction value
...
5.4.2.1 Line resistivity
If you selected the 2-wire measuring method in 5.4.2,
the display shows
Input here the line resistivity of your 2-wire probe for
long connection cables. If the resistivity value input
here is wrong, the displayed result will not be correct.

5.4.4 Temperature unit

Selection in the menu
positive or negative. The input is always made with one
decimal place.
...
Note :
The fields with a grey background
contain the factory-set default
values.
...
Unit
Display in °C
Display in °F
Correction value in 0,1 °C/0,1 °F,
depending on the unit selected