Elkron TM24-B Mode D'emploi page 7

INSTALLATION
Fixing
hole
Fixing
hole
Fix the device following the instructions reported below:

Remove the cover from the device by acting on the clips.

In the cable passage use the M20 cable/tube gland.

Install on a wall by using the relevant fixing holes placed on the bottom of the enclosure (as
illustrated in figure 2).

Connect the device TM24-B according to the connections diagram (see figure 4).

Insert the 2 provided rubber blocks, as illustrated in the figure 3, on the retention hooks with lower
protrusion; close the cover on the device by observing the alignment arrows .

Secure the cover with the provided screws.

Apply the supplied stickers in "A" positions as indicated in the rear view, on the clips for front
panel opening and on the top side cable passage if not used.
How to replace the pictographs into the device:

Remove the cover from the device by acting on the clips.

Remove the transparent part from the cover by acting on
the clips.

Insert the desired pictograph between the transparent part
and the cover.

Re-assemble the transparent part on the cover and insert
the 2 provided rubber blocks, as illustrated in figure 3, on
the retention hooks with lower protrusion; close the cover
on the device by observing the alignment arrows .

Secure the cover with the provided screws.
Clip for
front panel Cable passage
opening
A
Cable passage
A
Clip for
Cable passage
front panel
opening
289
Figure 2 - Rear view – dimensions in mm
Clip for
front panel
opening
A
Cable passage
Clip for
front panel
opening
311
7/20
Fixing
A hole
A
Fixing
hole
Figure 3