Sage The Big Squeeze BJS700 Guide Rapide page 11

6. Under running water, clean the outside of the
juicing screw with a dish scrub. Use the tip of
the cleaning brush to push out any residue in
the crevices on the bottom of the juicing screw.
Thoroughly clean the juicing screw ensuring that
the juicing screw is clean without any residue.
Thoroughly dry the bottom of the juicing screw.
After juicing ingredients with seeds, make
sure to thoroughly clean the bottom crevice
of the juicing screw. (If this area isn't properly
cleaned, it can cause the part to be damaged).
7. Clean the body with a soft damp towel and dry.
If the towel is dripping wet, make sure to
squeeze out the excess liquid before using
it on the juicer.
CLEANING SILICONE PARTS
Clean the rotation wiper under running water.
Thoroughly dry after cleaning. Before assembling
the top-set, ensure that the compression silicone
and silicone ring are firmly inserted.
If the compression silicone and silicone ring
are not firmly inserted, juice may leak from the
bottom of the juicing bowl.
COMPRESSION SILICONE
Unplug to clean.
After cleaning, firmly insert into the slot below
the pulp spout.
SILICONE RING
Remove the silicone ring from the juicing
bowl to clean.
After cleaning, push in the silicone ring with the
smaller surface facing down.
SMART CAP
Remove from the juice spout to clean.
After cleaning, attach the smart cap to the
smart cap silicone on the juice spout.
EN
11