Makita CF101D Manuel Du Propriétaire page 11

Starting / stopping the fan (Fig. 1, 2)
Push the power switch button (1) to turn on the fan. Push the power switch button again to turn off the fan.
Changing wind speed (Fig. 5)
Push the wind speed change button (2) while the fan is running. The wind speed increases every time you push the
button. The wind speed will return to the lowest speed when running in the highest speed.
The cordless fan will start in the same speed as the previous setting.
Adjusting fan head angle (Fig. 6, 7)
The angle of the fan head can be adjusted manually. The range of motion in the fan head is as shown in the figure.
For DCF102, press and hold the release button (8) when adjusting the fan head angle.
NOTE:
Do not turn the fan head further than its range of motion.
Oscillating the fan head (Fig. 8)
Push the oscillation button (4) to oscillate the fan head. Push the button again to stop the oscillation.
The fan head begin to oscillate from the current position when the oscillation button is pushed. The fan head oscillate
90-degree angle of range.
CAUTION:
• When oscillating the fan head, keep obstacles clear of the moving range of the fan head. The cordless fan may be
pushed and fall by the oscillation.
• Do not stop the oscillation by holding the fan head. Always push the oscillation button to stop.
NOTE:
Depending on the fan head position, the fan head may not oscillate soon after the oscillation button is pushed
because of the oscillation mechanism.
Auto-off timer (Fig. 9)
Push the auto-off timer button (3) while the fan is running. The duration to activate auto-off timer changes every time
you push the button (1 hour / 2 hours / 4 hours / off).
The number under each auto-off timer indicator shows the remaining hour(s) to turn off the fan. The auto-off timer
indicator will turn off with time.
NOTE:
Depending on the battery cartridge type and its remaining capacity, the auto-off timer may be activated earlier than
the set time.
Hanging the fan (Fig. 10)
Use the hook (10) on the handle to hang the cordless fan on a pole or other usable places. To prevent the cordless
fan accidentally dropped, attach a strap using the strap hole (7) and secure it.
CAUTION:
• Never hook the cordless fan at high locations or on the surfaces where the appliance may lose the balance and fall.
• For hanging the cordless fan, use a hard material such as a metal pole. The diameter of the hooking pole should be
smaller than 24 mm (15/16") and withstand 8.0 kg (17.5 lbs). Do not hang the cordless fan higher than 2.3 m.
Mounting on a tripod (Fig. 11)
The cordless fan can be mounted on Makita tripod.
When using the tripod with the threaded shaft 5/8"-11 UNC, mount the cordless fan using the screw hole (18).
Using AC adaptor (optional accessory)
WARNING
• Never use the cordless fan when the cord or plug is damaged.
• Do not handle the plug with wet or greasy hand.
• Do not leave the AC adapter disconnected from the cordless fan while the power is supplied from the mains. Small
children may put the live plug in their mouth and cause injury.
Insert the 12V DC plug of AC adaptor into the 12V DC socket (Fig. 1, 2), and then plug the AC pins into a main power
supply. Make sure that the voltage rating of the main power supply corresponds with that of the adaptor.
11