Nemaxx VKM0325LED Mode D'emploi page 4

Matchable R tubular motor setting up (additional function)
Delete all the datas of the motor and new emitter has benn programmed
During the settings, the time between two operation must be shorter than 4s, otherwise it will quit the
settings.
(setting button) x 1
● Sound from motor
hear long sound
● power on
Lamp control (only workable for receiver with lamp control) (additional function)
Press the lamp control button circularly to switch the lamp on and off circularly
● power on
Press lamp control
button once
EN
(setting button) x 1
● Beep once
Lamp on
4
up x 1
● Beep
once
down x 1
Press lamp control
button once
v1 • 04.03.2021
● Run or beep
for hint
Set up is ok.
The up button control
the motor clockwise
● Run or beep
for hint
Set up is ok.
The down button control
the motor clockwise
Lamp off