Residual Risks; Operation; Switching On/Off; Inserting/Replacing The Tool - Deltafox DP-EIW 4533 Traduction De La Notice D'utilisation Originale

GB
d) Immediately switch off the power
tool if the tool insert is blocked due
to overloading or tilting of the com-
ponent part. The loss of control can
result in injuries.
e) The device must only be connected to
a mains socket via a residual-current
circuit breaker (RCD) with a rated leak-
age current of not more than 30 mA.
f) If replacement of the connecting cab-
le becomes necessary, this is to be
carried out by the manufacturer or his
agent in order to avoid safety risks.

Residual risks

Even if properly operating and handling
this electric tool, some residual risks will
remain. Due to its construction and build,
this electric tool may present the following
hazards:
a) Injuries caused by moving parts or hot
surfaces.
b) Ear damage if working without ear
protection.
c) Damage to your health caused by
swinging your hands and arms when
operating the appliance for longer pe-
riods of time or if the unit is not held or
maintained properly.
Warning! During operation, this
electric tool generates an electro-
magnetic field which, under certain
circumstances, may impair the
functionality of active or passive
medical implants. To reduce the
risk of serious or lethal injuries, we
recommend that persons with
medical implants consult their doc-
tor and the manufacturer of their
medical implant before operating
the machine.
18

Operation

Switching on/off

Make sure that the power supply
voltage matches the voltage rating
indicated on the device's type plate.
Connect the machine to the power
supply.
1. Press the on/off switch (3). The
device runs at the maximum
speed.
2. To turn it off, release the on/off
switch (3).

Inserting/replacing the tool

1. Push the desired bit (11-14)
onto the tool holder (1).
2. To remove it, pull the bit off from
the tool holder (1).

Set the direction of rotation

You can toggle between right and left ro-
tation by pushing the direction of rotation
switch (5).
The direction changed may only be
performed in standstill mode!
1. Clockwise direction: Push the
directional switch (5) to the right
up to the stop.
2. Counter-clockwise direction:
Push the directional switch (5)
to the left up to the stop.